That single computer is usually identified by an IP address also so it is common for that single computer to have a static, or fixed, IP address. Port Forwarding allows you to configure your network hardware device to pass on all requests received on a specific port (such as 5003) on a public IP address to a single computer that exists on your private LAN. A good resource on the Internet for information like this is This is generally a pretty routine thing to do, but due to the sheer number of routers and firewalls available today, it is beyond the scope of this document to specifically explain how to do it for the hardware you might have. Therefore, it is up to you or your network administrator to configure these devices to allow network traffic though on port 5003. The purpose of a router or firewall is to keep unwanted network traffic from entering your private LAN so generally a router or firewall has only commonly used ports open by default. Both of these pieces of hardware usually stand between your local / private network (private LAN) and the outside world and act as a “network” traffic cop – allowing the authorized network traffic to pass thought and stopping the unauthorized traffic from either entering and/or leaving your private LAN.įor security reasons, most routers and firewalls, by default, are not likely setup to automatically allow network traffic on port 5003. The most common cause of a port being blocked is due to a piece of network hardware – either a router or a firewall. If port 5003 is blocked it can effect the network sharing functionality of FileMaker Pro. The primary port used for FileMaker network sharing is 5003. The network file sharing in FileMaker Pro and FileMaker Server also uses ports to communicate with other FileMaker Pro and web clients.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |